Filter
Top Products
13
3D
13.1
What you need
For Active 3D sets
This is an Active 3D TV. On this TV, you can watch 3D
programmes and movies in full High Definition resolution with
Active 3D.
To watch 3D you need to :
• Tune to a TV channel that broadcasts programmes in 3D.
• Rent a movie in 3D from an online video store with Smart TV.
• Watch a movie in 3D from a 3D Blu-ray Disc, a USB device or
computer.
Also, to watch 3D on this TV, you will need one of these types
of Philips Active 3D glasses. . .
• PTA507
• PTA508
• PTA509
• PTA517
• PTA518
• PTA519
13.2
The 3D glasses
For Active 3D sets
Overview
1 - On or off switch
2 - Player 1 or player 2 selection
3 - Receiver lens
4 - Battery compartment
When you unpack the 3D glasses, also remove the small plastic
foil from the battery compartment that prevents the battery
from running empty.
Switch on and off
Switch on
When a 3D programme is shown on screen, press
on the 3D
glasses and put them on. The glasses need some seconds to
adjust to the 3D signal from the 3D transmitter on the TV. At
first use, this may take up to 15 seconds.
Battery level
You can check the battery level when you switch on the 3D
glasses.
• If the LED light blinks green, you can use the glasses for 4
hours or more.
• If the LED light blinks orange, you can use the glasses for at
least 2 hours but less than 4.
• If the LED light blinks red, the battery is almost empty and less
than 2 hours of 3D watching remain.
Switch off
To switch off the 3D glasses, press
. The LED light blinks red 4
times. When the 3D glasses do not receive 3D signals for 2
minutes, the glasses switch off automatically.
3D transmitter
Make sure the receiver lens in the centre of the glasses can
receive the 3D signals. Also, clear objects away from the 3D
transmitter on the TV.
1 - 3D transmitter on the TV
2 - 3D receiver on the 3D glasses
Two-player gaming
You can use these glasses to play two-player games. Two players
can watch the same TV but see two different screens to play a
game.
To switch the glasses to watch the Player 1 or Player 2 screen,
switch on the glasses and then press the
Player 1/2
key.
• If the LED light is orange and lits continuously for 2 seconds,
the glasses are set for player 1.
• If the LED light is orange and blinks, the glasses are set for
player 2.
For more information, press
Keywords
and look up
Two-
player gaming
.
Replacing the batteries
To replace the battery of the 3D glasses PTA508, unscrew the
small battery lid and replace the battery: type CR2032 (3V).
Make sure the + side of the battery is visible. Replace the lid and
fix it with the screw.
To replace the battery of the 3D glasses PTA509, PTA519,
press the small knob on the battery lid and slide the lid up to
open. Replace the battery: type CR2032 (3V). Make sure the +
side of the battery is visible. Replace the lid and slide it down
until it clicks.
Warning
• Do not ingest battery, chemical burn hazard.
• This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal
burns in just two hours and can lead to death.
46