Filter
Top Products
Keywords
and look up
Common Interface CAM
.
CAM
Insert a CAM module
Switch off the TV before inserting a CAM.
Look on the CAM for the correct method of insertion. Incorrect
insertion can damage the CAM and TV.
Use the Common Interface slot on the TV to insert the CAM
card.
With the front of the card facing towards you, gently insert the
CAM as far as it will go.
Leave the card in the slot permanently.
It may take a few minutes before the CAM is activated.
Removing the CAM will deactivate the broadcast service on TV.
If a CAM is inserted and subscription fees are paid, (connection
methods can differ), you can watch the TV broadcast. The
inserted CAM is exclusively for your TV.
CAM settings
To set passwords or PIN codes for the CAM TV broadcast,
press
and select
Setup
and press
OK
.
Select
Channel settings
>
Common Interface
.
Select the CAM TV broadcaster and press
OK
.
4.4
Set-top box - STB
Use 2 antenna cables to connect the antenna to the Set-top box
(a digital receiver) and the TV.
Next to the antenna connections, add an HDMI cable to
connect the Set-top box to the TV.
Alternatively, you can use a SCART cable if the Set-top box has
no HDMI connection.
Switch off timer
Switch off this automatic timer, if you only use the remote
control of the Set-top box. Do this to prevent the TV from
switching off automatically after a 4 hour period without a key
press on the remote control of the TV.
To switch off the Switch off timer, press
and select
Setup
and
press
OK
.
Select
TV settings
>
General settings
>
Switch off timer
and
set the slider bar to
Off
.
4.5
Satellite receiver
• Connect the dish antenna cable to
the Satellite receiver.
Next to the antenna connection, add an HDMI cable to connect
the device to the TV.
Alternatively, you can use a SCART cable if the device has no
HDMI connection.
15