Filter
Top Products
SAFETY BELT
25• A: Make sure that the brace is properly inserted by
pushing as shown in the figure. B: Fasten the belt
as shown in the figure.
26• To unfasten the belt, press on the buckle sides
and pull out the waist strap.
27• The new safety belt is now easier to fasten thanks
to the "snap-open-and-shut" device. Before
fastening the safety belt, attach the buckle to the
backrest by inserting the tab through the special
holder, as shown in the figure. After fastening
the safety belt on your child, detach it from the
backrest to allow the child more freedom of
movement. The buckle must remain below the
child's shoulders.
ADJUSTING THE FOOTBOARD
28• The footboard can be adjusted to three different
positions. To lower the footboard, pull the two
small levers downward while lowering. To lift the
footboard, pull it up until it clicks into place.
ADJUSTING THE BACKREST
29• The backrest can be reclined in four positions. To
lower the backrest, raise the handle as you lower
the backrest, blocking it in the desired position.
To raise it, push the backrest upward.
SWIVELLING WHEELS
30• To make the front wheels swivel, push down as
shown in the figure. To fix the wheels, pull up the
lever.
SIDE DRINK HOLDERS
31• The stroller is equipped with two side drink
holders that fold away or pull out as necessary. To
pull the drink holders out, lift the upper part and
lower the bottom part, as shown in the figure.
32• Turn the disk outwards, and place your drink in
the holder. To clos e the drink holder, carry out
the instructions in reverse order.
FOLDING UP THE STROLLER
Before folding the stroller, loosen the braces if
the hood is attached, and raise the backrest if it is
lowered.
33• The stroller can be folded up using one hand
only, as follows. Place the stroller as shown in the
figure. Pull the lever, turn the knob, and lower the
handlebar. The stroller will automatically fold up.
34• Check the side safety hooks to make sure the
stroller is correctly folded up. When folded up, the
stroller will stand upright.
TRANSPORTING THE STROLLER
35• When folded up, the stroller can be carried by its
side handle, as shown in the figure.
REMOVABLE LINING
36• To remove the strollerʼs lining, loosen the
fasteners on the armrests as shown by the arrows.
37• Unbutton the sack at the side, as shown in the
figure. Slip the leg divider on the safety belt out
from under the seat.
38• Unbutton the sack from the seat and slip it off the
footboard hooks. Slip the sack off the top of the
stroller.
GANCIOMATIC SYSTEM
The Ganciomatic System is the swift, practical system
that allows one to fasten the following products,
which can be bought separately and are also equipped
with Ganciomatic System, to the stroller, thanks to
Ganciomatic fasteners.
• Primo Viaggio: a car seat with base, it can be
detached from its base (which stays in the car)
and attached to the Ganciomatic fasteners of the
stroller to transport your child without disturbing
him/her.
• Navetta: the comfortable bassinet unit becomes
a carriage when attached to the fasteners of
the stroller. Equipped with a foldable hood and
carrying handle, both the air circulation regulation
system inside the bassinet and the inclination
of the backrest are adjustable from outside. At
home, it rocks like a cradle and, when the stand is
taken away, it becomes a little bed.
• Porte-Enfant GM: light and practical for carrying
your child around, it turns into a carriage when
attached to the Ganciomatic fasteners on the
stroller, and, as it is not equipped with its own
hood, it uses the reversible hood of the stroller.
When your child is older, the padding turns into
a second padded sack with hood to install on the
stroller.
STROLLER GANCIOMATIC HOOKS
39• To raise the Ganciomatic hooks on the stroller,
pull the sack up at the corners of the seat and
turn the two hooks upwards until they click into
place.
40• To lower the Ganciomatic hooks on the stroller,
pull the little lever outwards and turn the hooks
upwards at the same time, as shown in the figure.
A3 + PRIMO VIAGGIO
41• To fasten the car seat to the stroller:
- set the brake on the stroller;
- remove the hood from the stroller;
- completely lower the backrest on the stroller;
- raise the Ganciomatic hooks on the stroller;
- place the car seat, turned towards the adult, on
the stroller and push downward until it clicks into
place.
- Do not remove the front bar of the stroller when
attaching the car seat, and make sure that it is in
its original position.
• See the userʼs manual for instructions on how to
detach the car seat from the stroller.
A3 + NAVETTA
42• To fasten the Navetta bassinet unit to the stroller,
you must:
- put the brakes on the stroller;
- remove the hood from the stroller;
- lower the backrest of the stroller completely;
- raise the Ganciomatic fasteners on the stroller;
- remove the front bar and insert the plugs provided
to close the armrests of the stroller;
- raise the footrest on the stroller to the highest
possible position;
- hold onto the handle of the Navetta;
- position the Navetta on the Ganciomatic fasteners
of the the stroller, keeping the head end of the
bassinet at the end of the stroller opposite the
handlebar;
- press down with both hands on the sides of the
Navetta until you hear a click.
• To unfasten the Navetta bassinet unit from the
stroller, consult its instruction manual.
A3 + PORTE-ENFANT GM
43• To fasten the Porte-Enfant GM to the stroller, you
must:
- put the brakes on the stroller;
- remove the hood of the stroller if it is placed by
the backrest;
- lower the backrest of the stroller completely;
- raise the Ganciomatic fasteners on the stroller;
- remove the front bar and insert the plugs provided
to close the armrests of the stroller;
- raise the footrest on the stroller to the highest
possible position;