Filter
Top Products
GB
4. INSTALLING THE MAXI-COSI CABRIOFIX IN YOUR CAR
4.1 Installing the Maxi-Cosi CabrioFix with a safety belt
The Maxi-Cosi CabrioFix can be fitted safely on almost all forward-facing seats in the car using the existing
seat belts. However, the belts are fitted so far forward on some seats that proper installation is not possible.
If this is the case, try another seat.
In some cases, the buckle of the safety belt may be too long and therefore sits too high against the base of
the Maxi-Cosi CabrioFix, making it difficult to install the Maxi-Cosi CabrioFix securely. If this is the case,
choose another position in the car. Contact your supplier with any questions.
*if there is a seat belt present in the middle position of the back seat.
Important! Do not mix up hip (9,1) and shoulder part (9,2)!
• Place the Maxi-Cosi CabrioFix in a rearward-facing position on the seat, therefore with the back forward
facing. The carrying handle must be locked in an upright position (10).
• Thread the lap section of the seat belt across the front (foot end) between the shell and two blue belt
hooks (11).
11
10
9
Instructions for use
13
• Installation with 3-point safety belt Yes
• Installation with 2-point safety belt No
• On passenger seat Yes
• On left/right side of back seat Yes
• In middle position of back seat Yes*
• Belt routing marking Blue
• Frontal airbag No
• Side airbag Yes
0114_GBA_cabriofix_I_BW 15-03-2006 12:30 Pagina 13