Filter
Top Products
GB
English
16
6. MAINTENANCE
6.1 General
Remove the car seat from the car before carrying out any maintenance work.
• The seat can be cleaned with soap and lukewarm water. Do not use any abrasive detergents.
• The belt buckle can be cleaned using warm water. Do not lubricate.
• The cover must be washed by hand (maximum 30°C). Do not use a dryer (also see washing instructions).
• Important! Never remove the energy absorbing foam.
Tip: It is advisable to buy an extra cover when purchasing the Maxi-Cosi CabrioFix, so that you can continue
using it even when the cover is being washed or dried.
6.2 Removing the cover
• First remove the belt pads.
• Open the rim at the sun canopy as far as possible (21 & 22).
• Remove the cover from the hooks (8x) (27).
• Remove the cover then from under the hooks and quick adjuster button (28).
• Pull the buckle tongue sections and adjustment strap through the openings.
6.3 Refitting the cover
• To refit the cover, carry out the above instructions in reverse order.
• Make sure that the lower section of the cover flaps over the uppersection.
• When closing the rim, make sure the sun canopy is stored properly in the rim.
• Fasten the adjustment strap under the shell again.
7. WASTE SEPARATION
To ensure optimum and safe use of car safety seats, they should not be used for longer than 5 years after
the date of purchase. Ageing of the plastic, for instance under the influence of sunlight (UV), may quite
unnoticeably reduce the qualities of the product.
Once the child has grown out of the seat, we therefore advise you to no longer use the car seat and to
dispose of it in the proper way.
As we care for the environment we request the user to separate the waste produced at the start (packaging)
and end (product parts) of the life of the Maxi-Cosi CabrioFix.
28
27
2221
0114_GBA_cabriofix_I_BW 15-03-2006 12:30 Pagina 16