Filter
Top Products
17
206-4213
Custom Master TV Setup (Cont.)
6. (Optional) Add Custom Channel and Aux Input Labels:
2-5-4 + MENU Mode
Note: 2-5-4 + MENU Mode enables you to add/edit channel icons and
custom text labels in the PTC once the Master TV Setup has been
transferred as described in the previous step.
Access the Installer Menu, and press 2-5-4 + MENU SETTINGS on the
Installer Remote. Add/edit custom text labels and/or change icons for
the Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 27). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press MENU SETTINGS to exit 2-5-4 + MENU Mode.
7. Verify the TV setup.
As applicable, verify that the channel lineup, channel icons, and custom
text labels are correct. Also, make sure the TV features are set per your
requirements.
8. (Recommended) Lock the channel lineup.
Access the Installer Menu. Set item 028 CH. OVERIDE to 000 and
press OK to lock the channel lineup and restrict access to the TV
setup menus. Press OK again to save your changes and exit the
Installer Menu.*
The Master TV Setup is now ready to be copied to the predetermined
cloning tool—a USB memory device (.tlx or .tll le) or a clone programmer.
See cloning procedures in this document.
After verifying the TV Setup, set Installer
Menu item 028 CH. OVERIDE to 000.*
DIGITAL 19-3
WXYZ
MONO
STEREO SAP
Custom text label “WXYZ” created
in 2-5-4 + MENU Mode.
* This step prevents end users from
accessing channel settings (i.e., the
Channel Menu will be inaccessible/
grayed out).
028 CH. OVERIDE 000
(Continued from previous page)
5. Transfer the TV setup menu settings to the commercial controller (PTC):
2-5-5 + MENU Mode
Note: This step is essential for successful cloning using a USB memory device /
.tll file or a clone programmer. Without this step, the PTC will not contain any of
the TV setup menu settings.
Note: The maximum number of channels (analog, digital, and Aux inputs) that can
be transferred to the PTC is 141. An attempt to transfer more than 141 channels of
any combination will result in a Channel Map of exactly 141 channels; any extra
channels will not be available in the PTC Channel Map. For example, if you enabled
three Aux inputs in the Installer Menu and Auto Tuning found 141 channels, you
must edit the Channel Map to decrease the number of analog/digital channels to (at
most) 138.
a) After the TV channel lineup has been edited and channel label icons added, tune to the
channel (source) for which you wish to transfer TV setup menu settings.
Note: If you intend to use a clone programmer for cloning purposes, this must be either
an analog channel or Aux input.
b) Access the Installer Menu, and press 2-5-5 + MENU SETTINGS on the Installer
Remote to initiate the transfer of the Master TV Setup to the PTC. The TV exits the
Installer Menu and then tunes through the channels in the channel lineup during the
transfer. When the transfer is complete, the TV tunes back to the channel that was
tuned before the transfer began.