Filter
Top Products
The Big Caboose Stand-On Triple Instruction Manual
Rear Wheel Brakes
• Before placing any child into the stroller or removing them from the stroller, be certain that the
rear wheel brakes are engaged.
• To engage the rear wheel brakes, push down on the brake lever located on each rear wheel. See
Figure 13. The stroller may require slight forward or rearward movement in order to line up the
teeth on the brake with each wheel brake cluster.
• Check that the brakes are properly applied by attempting to push the stroller backward and
forward.
• To release the brakes, gently lift up on the brake lever. See Figure 14.
!
WARNING
Always set BOTH wheel brakes when the stroller is not being pushed so that
the stroller will not roll away. Never leave stroller unattended, especially on a
hill or incline, as the stroller may tip over or slide.
Adjusting the Footrests
Both of the footrests can be adjusted to two positions – horizontal or all the way down.
• To place the footrest into the horizontal position, pull up on the footrest and position the footrest
lower bar into the upper slot at the middle of the plastic bracket on the underside of the footrest.
See Figure 15.
• Ensure that the bar is located securely into this slot on BOTH sides of the footrest. Push down
on both sides of the footrest to ensure it is secure.
• To place the footrest into the down position, pull up on the footrest to release the bar from
the slot. Lower the footrest slightly while moving the bar into the lower slot of the plastic
bracket on BOTH sides of the footrest. See Figure 16.
• Lower the footrest to its down position. Note that the footrest will not “lock” into the down
position, but will remain there by gravity only.
!
WARNING
Never allow a child to step onto the footrest in either position in order to get into
or out of the stroller. This may cause the stroller to tip over and injure the child.
Figure 15 Figure 16
Page 7
Page 8
Figure 13 Figure 14