Joovy 43X Series Stroller User Manual


 
The Big Caboose Stand-On Triple Instruction Manual
Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant carrier that has been installed on the stroller. Note that the stroller can still be
folded with the car seat carrier support in place.
• Position the stroller with the handle bar closest to you.
• Place the canopies into their closed position and push them all the way forward toward the front
of the stroller as far as they will go.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock both front wheels in place with the locking levers facing forward.
• To fold, unlatch BOTH safety latches on the lower left and right side of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller. See Figure 28.
• While these mechanisms are in the upward position, push forward on the stroller using the
handle bar.
• Once the stroller begins to fold, push the handle all the way forward and down until the stroller
is completely folded. See Figure 29.
CAUTION: While folding the stroller, be careful to keep your ngers from being pinched by
moving parts.
• Secure the stroller in the folded position by engaging the locking latch on the right side of the
stroller over the extended rivet. See Figure 30.
Figure 29
Figure 28
!
IMPORTANT NOTE
When using your stroller as an infant car seat carrier, the
following are the compatible infant car seat models that the
Big Caboose Stand-On Triple will accommodate:
For the most updated list of compatible infant car seats, please either check our website
at www.joovy.com or call our Customer Service Department at (877) 456-5049.
Baby Trend® Latch-Loc and Flex-Loc
Britax® Companion™
Chicco® Key Fit Car Seat
Combi® Centre Series
Combi® Connection
Compass® Light and Portable Infant
Car Seat
Eddie Bauer® Infant Car Seat
(models 22-625 and 22-626)
Eveno® Embrace™
Graco® Safe Seat™
Graco® Snug Rider™ Series
Maxi Cosi Mico
Peg Perego® Primo Viaggio
Peg Perego® Primo Viaggio SIP
Safety 1st® Designer 22™
Page 13
Page 14