InStep 10K Stroller User Manual


 
5
H
J
I
To open stroller:
Grasp handle with one hand and pull up on the front
fork with your other hand. Lock both plastic latches
onto the lower frame, insert locking pin into hole in
latch and frame, lock the pin in place by slipping the
wire loop over the end of the locking pin (Figure G).
On Double Models repeat for other side.
To engage rear brakes:
Step lightly on the levers next to the rear wheels until
the cogs of the brakes engage the cogs of the wheel.
Repeat on other side. To release brake, lift levers using
your toe until cogs disengage (Figure H).
To operate front caliper brake:
The front brake operates the same as a bicycle hand
brake. Squeeze lever located on handlebar to engage
front brake. Release lever to disengage.
PROPER USE OF SEAT BELTS
& SHOULDER STRAPS:
WARNING: Avoid serious injury from falling or
sliding out. Always use seatbelt.
1. Place child in seat. Make sure T-shield is between
the child’s legs.
2. When child is seated, place shoulder straps over the
child’s shoulders.
3. Slide waist straps through lower loops of shoulder
straps, bring lap belt ends together and clip into
place around child’s waist. Adjust waist and shoulder
straps for snug fit (Figure I).
To recline seat:
To fully recline, unhook buckle on back of the seat
(Figure J).
To place seat in upright position, push seat forward and
reconnect buckle located on back of seat.
To adjust the recline position, adjust the slide on the
strap.
WARNING: Child may slip into leg openings and strangle.
Never use in a reclined carriage position unless
T-shield and shoulder strap have been readjust-
ed to the new seat position.
G
Inserted
Locked
Pin
Rear Axle
Release Lever
Rear Brake Lever
Shoulder Strap
Waist Strap
T-Shield