Filter
Top Products
Page 7SKU 97456 For technical questions, please call 1-800-444-3353.
General Operating Instructions
Place the proper Pad on the Sliding 1.
Bar (2A) of the tool. (See Figure C.)
Connect an air hose to the Air 2.
Connector (5A) of the tool. Turn
on the air compressor, and set its
regulator between 72 and 110 PSI.
Do not exceed 110 PSI.
(See Assy. Diagram.)
Insert Adapter (14A) onto the caliper 3.
of the vehicle. Push Sliding Bar
(2A) forward, rotating the Direction
Handle (18A) to left or right in order
to engage the pin/pins on the face of
the Pad with the holes on llister of
the Caliper. (See Figure D.)
FIGURE D
HEX SET SCREW (17A)
SLIDING BAR
(2A)
PAD
4. Squeezing the Trigger (6A) will force
Sliding Bar (2A) forward to expand
the Caliper. (See Figure E.)
DIRECTION HANDLE (18A)
TRIGGER (6A)
FIGURE E
5. When nished, release pressure on
the Trigger (6A). Then pull out on the
Sliding Bar (2A) to remove the Pad
from the caliper. (See Figure F.)
Turn off the air compressor. 6.
Disconnect the air hose from the tool.
Squeeze the tool’s Trigger (6A) to
release any remaining compressed
air in the tool. Then store the tool in a
clean, dry, safe location out of reach
of children and other unauthorized
people.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
FIGURE C
SLIDING BAR (2A)
PAD
FIGURE F
SLIDING BAR (2A)
PAD
TRIGGER (6A)
REV 08c