Filter
Top Products
8
Setup and Use
• Tighten each waist belt so that the restraint system is snug against
your child. Please refer to the next section for instructions to
tighten the waist belts.
2
Restraint System
B
A
A
B
To tighten the restraint belts:
• Feed the anchored end of the restraint belt up through the buckle
to form a loop
A
. Pull the free end of the restraint belt
B
.
To loosen the restraint belts:
• Feed the free end of the restraint belt up through the buckle to
form a loop
A
. Enlarge the loop by pulling on the end of the loop
toward the buckle. Pull the anchored end of the restraint belt to
shorten the free end of the restraint belt
B
.
Anchored End Anchored End
TIGHTEN
LOOSEN
Free End
Free End
3
e
m is snug against
s
tructions to
Soothing Unit and Toy Bar
Power Switch
PULL
• Make sure your child is properly secured in the seat.
• Slide the power switch to: Vibrations or Off.
IMPORTANT! Low battery power causes this product to operate
erratically: no vibrations and the product may not turn off. Remove
and discard the battery and replace with a new “D” (LR20)
alkaline battery.
• Pull the toy for sounds.