Filter
Top Products
5
• Fit a retainer to the inside of each end of the seat back tube.
• Insert #8 x 2,2 cm screw into the outside hole in the ends of the
seat back tube and tighten.
• Pull the seat back tube up to be sure it is secure. If you can
remove either end of the seat back tube, you have not assembled
the retainers correctly. Remove the screws, re-read and repeat.
Assembly steps 5 and 6.
6
Retainers
Assembly
• Position the pad above the frame.
• Fit the upper pocket on the back of the pad onto the seat back tube.
Pad Seat Back Pocket
7
Pad Lower Pocket
• Fit the lower pocket on the back of the pad onto the footrest.
8
• Fit the toy bar retainer through the side opening in the pad.
• Fit the edges of the soothing unit through the large opening in the
front of the pad.
9
Soothing Unit
Toy Bar Retainer
• Press the head support strap to the fastener on the back of the pad.
Hint: You can move the head support up or down for your
baby’s comfort.
10
Head Support