Filter
Top Products
4
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel for
replacement parts and instructions if needed. Never substitute parts.
• Place the base tube on a flat surface.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
Right Base Wire
Base Tube
Left Base Wire
1
Assembly
• Insert an M5 x 20 mm screw through each foot and tighten.
3
Non-skid Surface
2
• Position the feet so the non-skid surface is down.
• Fit the feet on the base tube, as shown.
• Position the footrest so that the soothing unit is upright.
• Fit the footrest onto the ends of the base wires.
Base Wires
Footrest
4
• Fit the seat back tube onto the ends of the base wire.
• Push the seat back tube to be sure it is completely on the
base wires.
Seat Back Tube
5