Filter
Top Products
M0411pr-0920
13
IMPORTANT! Use only a Power Wheels
®
6 volt (4.0 Amp/Hr.)
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
®
6 volt
(4.0 Amp/Hr.) charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will void
your warranty.
• Remove the #8-18 x 7⁄8" screw from the battery retainer. Lift to
remove the battery retainer from the vehicle.
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery in the battery
compartment. Make sure the battery connector extends toward the
rear of the vehicle.
• Replace the battery retainer over the battery. Insert the #8-18 x 7⁄8"
screw through the battery retainer and into the vehicle. Tighten
the screw.
• Locate the lock fasteners on the front edge of the seat.
• Using a slotted screwdriver, turn both lock fasteners ¼ turn to the
unlocked position .
• Grasp under the front of the seat and lift firmly to remove it.
LOCKED UNLOCKED
Battery Connector
Battery Retainer
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor harness
connector, turn it over and try again! Do not force the battery
connector into the motor harness connector.
• Re-assemble the seat to the vehicle. Using a slotted screwdiver,
turn the lock fastener ¼ turn to the locked position
.
IMPORTANT! Always remember to keep the lock fasteners locked at
all times to prevent children from accessing the battery.
BATTERY INSTALLATION
J
1
2
3
4