Filter
Top Products
Assembly
5
• Position a rear leg so that the tapered end is upright.
• While pressing the button on the top of the rear leg, insert it
into the housing short tube, as shown. Push the rear leg until
the button“snaps” into the hole in the short tube.
• Repeat this procedure to assemble the other rear leg to the
motor housing short tube.
• Pull the rear legs down to be sure they are secure in the
housings. If you can remove them, you have not assembled
them correctly. Please re-read and repeat this assembly step.
Button
Rear Legs
Motor Housing
Short Tube
• Fit the bottom of the remote into the cupped portion of
the holder.
• Push to“snap” the top of the remote under the holder clips.
Holder
6
• Position the holder so that the hole in the holder aligns with
the hole in the front leg.
• Insert the M4 bolt through the holder, front leg and into the
lock nut.
• Tighten the bolt with a Phillips screwdriver.
Do not over-tighten.
Holder
Front Leg
5
8
Tapered
End
• Position the housing so that the hub is inward.
• While pressing the button on the top of a front leg, insert it
into the housing slot, as shown. Push the front leg until the
button“snaps” into the hole in the housing.
• Repeat this procedure to assemble the motor housing to
the other front leg.
• Pull the front legs down to be sure they are secure in the
housings. If you can remove them, you have not assembled
them correctly. Please re-read and repeat this assembly step.
Press
Buttons
Front
Legs
Motor
Housing
Hole
Housing
Hub
Slot
7
Clips
Remote
M4 Bolt - 1
Shown Actual Size
B0323 Quick Response Swing 9/24/02 1:03 PM Page 5