Filter
Top Products
Assembly
7
•While holding the seat wire in place, carefully turn the
seat around so that the front faces you.
•Position the seat wire cap so that the rounded edge
is upright.
•Fit each end of the seat wire through the hole in each
seat wire cap.
Ends of
Seat Wire
•Press to “snap” the seat wire caps into place.
•Turn the seat face down.
•Fit an accessory bin into the groove on each side of the
seat, as shown.
• Insert two #8 x 1
1
/4" screws through each accessory bin and
into the seat.Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Seat Wire Cap
Seat Wire
Cap
Grooves
Seat
Accessory Bin
Accessory Bin
Seat Wire
Caps
14
15
16
• Lift the seat tubes slightly.
•With the seat wire hanging down, insert the ends of the seat
wire through the slots in the seat, as shown.
Slots
Seat Wire
13
#8 x 1
1
/4
”Screw - 4
Shown Actual Size
Seat Wire
Cap Hole
Rounded Edge Up
Seat Wire is
Through Hole in
Seat Wire Cap
“Snap”in Place
•Position the seat assembly so that the front of the seat is
toward the curved front base.
•While pressing the buttons on the swing tubes, insert them
into the frame hubs. Push the swing tubes up until the but-
tons “snap” into the hole in the frame hubs.
•Push down on the seat to be sure the seat is secured in both
frame hubs.
Swing
Tube
Front
of Seat
Curved
Front
Base
Push
Button
Frame Hub
17