Filter
Top Products
Assembly
5
9
• Insert and “snap” the cap into the hole in the frame.
Cap
11
• Fit the tab on the headlight cover to the slot in the top
of the handlebar.
• Insert two #8 x
3
/
4
" screws into the headlight cover.
Tighten the screws. Do not over-tighten.
Headlight Cover
Slot
12
• Turn the seat upside-down.
• Fit the small pegs on the seat retainer into the holes in
the seat.
• Insert the fork post up through the hole in the neck of
the frame. Make sure the fork is positioned so that
the fork covers face the rear wheels.
• Place the handlebar onto the fork post and push it
down onto the frame. Make sure the handlebar is posi-
tioned so that the screw hole faces the rear wheels
and aligns with the screw hole in the fork post.
• Insert the #8 x 3" screw through the hole in the
handlebar and into the fork post so that part of the
screw (about
3
/4") is still visible. Tighten the screw.
Handlebar
Frame
Neck
Fork
Post
Fork
Cover
Rear of Trike
Seat Retainer
Seat
Peg
Holes
3
/
4
"
FIRST, insert the screw
so that
3
/
4"
is visible.
THEN, tighten the screw.
10