Filter
Top Products
• Fit a retainer to the outside of the seat
back tube, as shown. Make sure the
socket in the retainer is upright.
• Insert a screw through the hole in the
seat back tube, base wire and into the
inside of the retainer.
• Tighten the screw with a Phillips screw-
driver.Do not over-tighten.
• Repeat this procedure to assemble the
other retainer to the other side of the
seat back tube.
• Pull up on the seat back tube to be sure it is secure. If you can remove
either end of the seat back tube, you have not assembled the retainers
correctly. Remove the screws, re-read and repeat Assembly steps 4 and 5.
Assembly
5
7
Seat Back Tube
Retainer
Socket
Up
Retainer
Socket
Up
PULL UP