Filter
Top Products
• Place the base tube on a flat surface
as shown.
• Position the left and right base wires as
shown. Note the location of the colored
tabs on the left and right base wires.
• Fit the left base wire into the base tube.
• Fit the right base wire into the base tube.
• Make sure both colored tabs on the base wires are visible through the
holes in the base tube.
1
Base Tube
Colored Tab
Back View
Base Wire
Assembly
Base Tube
Left Base Wire
Colored Tabs
Right Base Wire
5
2
Soothing Unit
Clip Screw
Footrest
Soothing Unit
• Loosen the screw in the soothing unit clip with a Phillips screwdriver.
• Slide the soothing unit onto the footrest, as shown. Make sure the footrest
is completely in the grooves around the sides and back end of the
soothing unit.
• Tighten the screw in the soothing unit clip with a Phillips screwdriver.
Do not over-tighten.