Filter
Top Products
7
Assembly
9
8
Upper
Hole
Cover
Slot
Tab
Metal Stay
Shown Actual Size
M4 x 1
13
/
16
" Screw - 2
M4 Lock Nut (Inside Frame) - 2
Rounded
Side
•Position one end of the metal stay against the upper hole
in a frame.
• Insert an M4 x 1
13
/
16
" screw through the hole in the cover.
•Fit the end of the screw through the hole in the metal stay,
the upper hole in the frame and into the lock nut.
•Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
•Repeat this procedure to attach the other end of the metal
stay and the remaining cover to the frame on the other
side of the base.
Hint: Alock nut has been factory assembled to the frame.
During shipment,the lock nut may have fallen out of the
frame.If this has happened,please fit the lock nut back into
the upper hexagonal hole in the frame,so that the rounded
side of the lock nut faces out.You may find it easier to access
the hexagonal hole on the back of the frame if you push the
base up,so that the fabric is out of the way.
®
Pad
Fastener
•Fasten the pad fasteners to the base fasteners.
IMPORTANT! Assembly is now complete, but the Activity
Dome is NOT ready for use. Please refer to the Set-Up & Use
instructions, beginning with step 2.
•Push on the cover to insert and “snap” the tab on the cover
into the slot in the frame.Make sure you hear a “snap”.