Filter
Top Products
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other ends of the
frame tubes to the frame on the other side of the base.
5
• Position the base wires around the base so that the
ends point upward and are in front of the lower holes
in a frame.
• Insert an M6 x 1
3
/
8
" screw through each base wire and
into the frame.
• Fit an M6 lock nut into each corresponding hexagonal
opening on the back of the frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other ends of the
base wires to the frame on the other side of the base.
6
Base Wire
Lower Hole
Base Wire
Frame
5
• Position one end of the metal canopy stay against the
upper hole in a frame.
• Insert an M5 x 1
13
/
16
" screw through the hole in
the cover.
• Fit the end of the screw through the hole in the metal
canopy stay and into the hole in the frame.
• Push on the cover to insert and “snap” the tab on
the cover into the slot in the frame. Make sure you
hear a “snap”.
• Fit an M5 lock nut into the corresponding hexagonal
opening on the back of the frame.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other end of the
metal canopy stay and the remaining cover to the
frame on the other side of the base.
Assembly
Upper
Hole
Cover
Slot
Tab
Lower Hole
M6 Lock Nut - 4
M5 x 1
13
/
16
" Screw - 2
M5 Lock Nut - 2
Metal Canopy Stay
7
M6 x 1
3
/
8
" Screw - 4