Filter
Top Products
6
9
OFF
SP
LP
OFF
SP
LP
11
10
• Slide a retainer between the two ribs on one side of the tray,
as shown.
• Fit an M5 lock nut (protruding side facing away from the
retainer) into the hexagonal hole in the retainer.
• Fit a
5
/
16
" washer onto the M5 bolt. Insert the M5 bolt through the
frame, hub, tray and into the retainer. Tighten the bolt with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to fasten the other side of the tray to the
other frame.
Retainer
Rib
Rib
Tray
M5 x 3
9
/
16
" Bolt
M5 Lock Nut
• Position the head with the face upright.
• Insert and snap the tab on the head into the slot in the tray.
• Insert two
5
/
8
" screws with washer heads through the front holes
in the tray and into the head. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• Insert two
5
/
8
" screws with washer heads through the back holes
in the tray and into the head. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Head
Tab
Slot
Tray
Protruding
Side
Frame
M5 Lock Nut
ASSEMBLY
5
/
16
" Washer