Fisher-Price 79026 Baby Furniture User Manual


 
FCC Note
(United States Only)
Note:This equipment has been tested and found to comply
with the limits for a Class B digital device,pursuant to
Part 15 of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.This equipment generates,uses and
can radiate radio frequency energy and,if not installed and
used in accordance with the instructions,may cause harmful
interference to radio communications.However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user‘s authority to operate the equipment.
Fisher-Price,Inc.,a subsidiary of Mattel,Inc.,East Aurora,NY 14052 U.S.A.
©2002 Mattel,Inc.All Rights Reserved.® and ™ designate U.S.trademarks of Mattel,Inc.
Printed in China 79026pr-0920
Care
The pad is machine washable.Wash the pad separately in
cold water on the gentle cycle.Do not use bleach.Tumble
dry separately on low heat and remove promptly.
The frame, toy bar and toys may be wiped clean using
a mild cleaning solution and a damp cloth. Do not use
bleach. Do not use harsh or abrasive cleaners.Rinse clean
with water to remove residue.
To remove the pad:
Unfasten the buckles around each side rail.
Turn the seat face down on a flat surface.Unfasten the
buckles on the pad.
Turn the seat upright.Remove the hardboard from the
slot in the front edge of the pad.
Pull the front and back of the seat back area of the
pad apart.
Lift the pad off the seat.
To replace the pad, refer to Assembly steps 8 and 9.