Filter
Top Products
Rear seat: Remove mounting bar
from between frame beneath front
seat. (Grasp red handle and push
toward center of bar to release from
frame.)
Place mounting bar into the two
holes on the inside of stroller arms.
Put one end in first, the pull in on the
other end to put into second hole.
14
To Attach Car Seats:
15
To Remove Car Seats:
Front seat: Place seat back in upright
position. Remove mounting bar from
back of front seat frame. (Grasp
one
end and pull back to release bar from
seat frame).
Note: When using two car seats,
1. The front stroller seat must be
forward-facing.
2. Both car seats must be rear-facing.
3. Both front and rear trays must be
in place when car seats are attached.
4. Make sure both car seats are
locked in place before placing child
in car seat.
Place mounting bar into the two holes
on the inside of seat back as shown.
Put one end in first, then, compress
bar to place other end into second
hole. Place seat in upright position.
Pull up on the 1-hand release handle
on back of car seat and place car
seat rear facing into mounting bar
firmly (listen for locking click) until
fully locked.
To remove each car seat, pull up on
the 1-hand release handle and lift
car seat out.
If you have an Eddie Bauer
®
, Cosco
®
or Safety 1st
®
02-600 or 22-600 series infant car seat(s), the following instructions
explain how to attach the car seat(s) to the stroller. Complete instructions for using the car seats are located on the back
of the car seat.
With back of stroller seat in the re-
clined position,
pull up on the 1-hand
release handle
on back of car seat and
place seat rear facing into mounting
bar firmly (listen for locking click).
9
WARNING:
To avoid serious injury
• Always use tray when car seat
is attached.
• Always attach car seat facing to
the rear of the stroller.
• Always use the restraint system.
• Place mounting bar in storage
position when not in use.
!