Filter
Top Products
Face seat forward and align sockets
on seat with brackets on frame. Push
down until seat locks with a click.
To attach seat in rear-facing position,
press red buttons on sides of seat to
release locks, lift seat off brackets.
Rotate seat 180 degrees, align sock-
ets with brackets and push down
until seat locks with a click.
4
To Install Front Seat:
6
To Install Trays:
5
To Install Canopies:
5
Front Canopy: Align canopy tabs with
sockets in seat sides, push down
until locked. Note: Vent in canopy
goes toward back of seat as shown.
Rear Canopy: The rear canopy comes
partially installed over frame. To com-
plete, canopy hinge brackets must be
attached to stroller frame.
Snap canopy hinge brackets onto frame
just below “armrests”, aligning hole in
brackets over pins on frame as shown.
Parent Tray: From front of handle,
insert tray between handle frame.
Align holes in tray brackets with pins
on each side of frame as shown.
Gently pivot tray down until brackets
snap around handle frame.
pin
pin