Filter
Top Products
21
Refer to vehicle owner’s manual to identify the seating locations which can be used with a car
seat. Check for specific instructions for car seat use.
After selecting a seating location, if vehicle seat back is adjustable, adjust seat back into most
upright position.
With car seat adjusted into recline position #1, place car seat forward-facing in the vehicle
seat location selected with base contacting vehicle seat back (fig. a).
Route vehicle seat belt through car seat by inserting vehicle seat belt into space between
seat back and front of base. Pull out through opposite side.
Buckle vehicle seat belt and remove any slack in lap belt. Check that vehicle lap belt is not
twisted.
Position vehicle lap belt in the forward-facing belt path location by placing vehicle
lap belt between raised ribs in forward-facing belt path identified by the red
“Belt Here” arrows (fig. b).
• Not all vehicle seat belts can be used with this car seat. Read vehicle owner’s manual and “Vehicle Seat
Belts” section in this manual.
•Vehicle seat belt MUST stay tightly adjusted around car seat at all times. If vehicle seat belt does not stay
tight, read the vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.
WARNING
DEATH or SERIOUS INJURY can occur
1
2
3
Forward-facing
Belt Path
(fig. a)
(fig. b)
4
5
6
9c.Forward-facing Installation With Vehicle Seat Belt
Forward-facing
Belt Path
22
Tighten vehicle seat belt to secure the car seat.
For vehicle lap only belts:
- Press down in center of car seat to depress the vehicle seat cushion while tightening
vehicle lap belt (fig. c).
For vehicle lap and shoulder belts:
- Open shoulder belt lock-off on side of base opposite vehicle seat belt buckle.
To open shoulder belt lock-off, rotate locking tab down and lift lock-off cover (fig. d).
- Position shoulder belt in shoulder belt lock-off, tighten lap and shoulder belt and close
shoulder belt lock-off onto shoulder belt to secure car seat.
To close shoulder belt lock-off, push lock-off cover down and rotate
locking tab up (fig. d).
Adjust car seat to desired recline position #2, 3 or 4.
-To change recline position, see “Recline Position Adjustment” section.
- Seat recline position can be adjusted between positions without
unsecuring vehicle seat belts.
NOTE: Use only position #2, 3 or 4 for forward-facing.
Check for secure installation. Gripping car seat at top of armrest, pull
car seat front to back and left to right to check for secure installation
(fig. e). Vehicle lap belt MUST stay tight.
If the vehicle lap belt does not stay tight or car seat can not be securely
installed, see vehicle owner’s manual, “Vehicle Seat Belts” section in this
manual or move to a different seating location.
Attach top tether hook (A) to vehicle top tether anchor hardware (B)
(fig. f) and pull strap to tighten top tether removing any slack.
If top tether anchor (B) is not available in vehicle, see vehicle owner’s
manual or Top Tether Information in “Selecting A Vehicle Seating
Location” section.
NOTE: If top tether is not in use, store by snapping tether hook on back
of base.
7
(fig. d)
(fig. c)
8
9
(fig. e)
(B)
(A)
Pull to
tighten
(fig. f)
10
Shoulder Belt
Lock-off
Lock-off
Cover
Locking
Tab