Filter
Top Products
19
Connect lower anchor connectors to vehicle lower anchors.
- With hook-on connector opening facing down , position the opening of the
connector over the vehicle lower anchor. Push down and then pull out on
the connector to lock it onto the vehicle anchor (fig. f). You should hear a click.
- Pull on connector to be sure it is locked onto the anchor.
- Repeat for connector on opposite side.
Tighten lower anchor belt to secure the car seat.
- Press down in center of car seat to depress the vehicle cushion and pull free end of lower
anchor belt to tighten belt (fig. g).
Check for secure installation. Gripping car seat at top of armrest, pull car seat front to back and
left to right to check for secure installation (fig. h). LATCH belt MUST stay tight.
- If LATCH belt does not stay tight or car seat can not be securely installed, try a different
LATCH location or use the vehicle’s seat belt to secure the car seat.
Adjust car seat to desired recline position #2, 3 or 4.
-To change recline position, see “Recline Position Adjustment” section.
- Seat recline position can be adjusted between positions without unsecuring vehicle seat
belt.
NOTE: Use only position #2, 3 or 4 for forward-facing.
Attach top tether hook (A) to vehicle top tether anchor hardware (B) (fig. i) and pull strap to
tighten top tether removing any slack.
- If top tether anchor (B) is not available in vehicle, see vehicle owner’s
manual or Top Tether Information in “Selecting A Vehicle Seating
Location” section.
6
(fig. h
(B)
(A)
Pull to
tighten
(fig. i)
7
(fig. g)
8
9
(fig. f)
2
1
3
1
2 3
5
20
Removal Of Car Seat Installed With LATCH:
Tip belt adjuster to loosen top tether strap (fig. j).
Depress retainer spring and unhook tether hook from vehicle top tether anchor (fig. k).
Loosen lower anchor belt by tipping adjuster and pulling out lower anchor belt.
- Pressing down in center of car seat to reduce tension on lower anchor belt will make it
easier to loosen lower anchor belt.
Remove hook-on connectors from vehicle lower anchors.
- Press and hold the connector retainer spring .
- Push connector in, then rotate connector , and pull out to unhook from the vehicle
anchor (fig. l). If the connector can’t be rotated, push in and lift the connector to unhook
from the vehicle anchor.
- Repeat to remove hook-on connector on opposite side.
Storage Of Lower Anchor Belt And Connectors:
When not using the LATCH System, store the lower anchor belt and hook-on
connectors by removing lower anchor belt and connectors from forward-facing belt
path and snapping hook-on connectors onto LATCH connector storage locations
on back of base (fig. m). Pull on free end of lower anchor belt to tighten.
1
2
Tether
Hook
Retainer
Spring
(fig. k)
1
2
1
2
3
2
3
4
(fig. j)
Belt
Adjuster
1
Lower Anchor
Connectors
(fig. l)
2
1
3
(fig. m)