Filter
Top Products
Locking Clip
37SECTION 10 - Installing the Car Seat without the Base 38SECTION 10 - Installing the Car Seat without the Base
LAP ONLY BELT
To install with a Lap only belt pass the belt
from one side of the carseat to the other. Fit
the belt under the lugs in front of the handle.
Pull the belt tight!
LAP/SHOULDER BELT
To install with a Lap/shoulder belt pass the
Lap belt from one side of the carseat to the
other. Fit the belt under the lugs in front of the
handle.
Fit a Locking Clip to the Lap and Shoulder
belts just above the vehicle belt latch.
Pull the belts tight!
NOTE: A Locking Clip MUST be used with a
Lap/Shoulder belt with a tongue that moves
freely along the belt, or with a Lap/shoulder
belt where the Lap portion of the belt cannot
be tightly secured.
LOCKING CLIP
A Locking Clip is supplied with the car seat
and is stored at the back of the carseat.
To fit the Locking Clip, first fit to the Lap Belt
as shown opposite, then fit the Shoulder Belt
through the Locking Clip over the top of the
Lap belt.
Keep the belts tight!
WARNING: If the Locking Clip is not used
where required, the car seat will not be
held securely in place.
Remove Locking Clip from the vehicle belt
when not in use.
DO NOT use the Locking Clip as a vehicle
belt shortener.