Filter
Top Products
"CLICK"
33
Section 9 - Installing the Car Seat Base with Vehicle Belts
34
Section 9 - Installing the Car Seat Base with Vehicle Belts
FITTING THE CAR SEAT INTO THE BASE.
Before putting the car seat into the base
make sure there are no objects on or in the
base.
Connect the car seat to the base.
NOTE: listen for a "CLICK" when the car seat
is installed into the base, and lift the car seat
to ensure the car seat is fully conected to the
base.
Some vehicle seats do not provide enough
support to hold the base up at the required
angle.
If extra support iis required a tightly rolled
towel or a firm foam roll (pool noodle) can be
used.
To remove the carseat from the base, pull
firmly upwards on the release lever at the rear
of the car seat, and lift the carseat upwards.
WARNING: DO NOT use the car seat if it
is not securely connected to the base.
Any extra support used to hold the car seat
up must not interfere with the Vehicle Belts.