Filter
Top Products
Press down
firmly on base
Pull
LATCH
strap
tight
25Section 8 - Installing the Car Seat Base with LATCH 26Section 8 - Installing the Car Seat Base with LATCH
The LATCH strap is stored in the base foot.
To remove the LATCH strap, swing the base
foot open by adjusting it to the maximum
downwards position and then pressing the
release catch.
Remove the LATCH strap from its storage
position.
If the LATCH strap is too short, rotate the
LATCH strap adjuster upwards to loosen the
LATCH strap.
Route the LATCH strap under the Vehicle Belt
Routing Tabs and over the top of the base as
shown.
Connect the LATCH strap connectors to the
vehicle anchorages.
Excess vehicle belt can be passed back
under the routing lugs and through the built-in
Locking Clip.
See page 31 for information on using the
built-in Locking Clip.
Press down on the base and pull the
LATCH strap as tight as possible.
LATCH strap stored in
base foot
WARNING:LATCH connectors must be
secured to the vehicle LATCH
anchorages only.
WARNING: Never attach more than one
anchor to a vehicle lower anchorage unless
recommended by the vehicle Owners
Manual.