Filter
Top Products
23
4. The Buggy Kit
The assembled buggy (base + buggy kit) – example Cougar1
4.1 Fitting the Buggy Kit:
Unscrew the star knob of the buggy
wheel and insert the wheel bolt from
below through the large hole in the
hitch arm attachment bracket.
Screw the star knob onto the threaded
area of the wheel bolt and tighten
securely. Repeat this on the other side.
The star knob has a plastic thread.
Safety Recommendation:
When using the carrier as a buggy always put the wrist strap, which is fastened securely on the left rear frame tube, around
your wrist (see illustration for jogging kit).
protector, this means the wheel bolt is
to be held tightly when turning off the
star knob.
When fitting the star knob all that is
needed is that the buggy wheel be
pressed hard on the ground by apply-
ing pressure on the hitch arm attach-
ment bracket. Repeat this on the other
side.
Parts supplied:
Buggy twin wheels
If you wish to use your Chariot CTS in
any other form than a buggy, it is very
easy to take the buggy wheels with
you. Simply insert them upside down
into the hitch arm attachment bracket
and secure them from below using the
star knobs. The fork arms need to point
forwards.
The star knob has a plastic thread pro-
tector, this means the wheel bolt is to
be held tightly when tightening up the
star knob. When fitting the star knob all
that is needed is that lateral pressure
be applied to the buggy wheel so as to
slightly twist the axle.
The fork of the buggy twin wheel must
sit in both guide grooves of the hitch
arm attachment bracket so that it can-
not be turned.