Filter
Top Products
16
WARNING
Rear wheel
7. Depress the button located in the center of the wheel hub on the
axle and then insert the rear hub axle (Fig. 29) into the axle tube
(Fig. 30) until it stops.
Test for wheel retention
8. Do these two tests to ensure that you have adequately
performed these procedures:
• Pick the front of the jogging stroller off of the ground, and give
the top of the front tire a sharp downward blow (Fig. 31). The wheel
should not come off, be loose, or move from side to side. If uncertain,
repeat the tightening process, as shown in Steps 2-6 of these
instructions.
• With the quick release lever properly adjusted and in a closed
position, you will not be able to rotate the quick release lever in a
circular motion parallel to the wheel (as opposed to the flipping motion
used to open and close the quick release lever- see Fig. 32).
9. For the rear wheel, test for a secure attachment by attempting
to pull the rear hub axle from the axle tube (Fig. 33). You should not
be able to pull the axle from the tube.
Lubrication
Regrease wheel bearings every year. This requires special tools and
training, so should only be done by your Chariot dealer.
Lubricate quick releases once a year. Apply several drops of light oil
where the quick release lever rotates in the quick release body.
Fig. 31
Failure to have wheel quick release retention mechanisms properly
adjusted and closed, may cause loss of control resulting in personal
injury. If you have any questions about the operation of this system,
consult your Chariot dealer.
Fig. 32 Fig. 33
Axle tube
Fig. 30