Filter
Top Products
4 Gather Playard frame together
while pulling up on Floor Loop.
5 Wrap floorboard around Playard
frame with padding facing in.
NOTE: Floorboard Handle MUST
be aligned with wheels as shown.
6 Secure Attachment Straps
by threading through loops
on end of floorboard and
folding back onto itself.
NOTE: Make sure floorboard
is positioned above wheels.
7 Position travel bag over Playard
so Handle comes through
Opening in side of bag.
Pull travel bag over Playard.
Pull Floor Loop through opening
on top of travel bag.
NOTE: To prevent rubbing,
make sure travel bag is
positioned above wheels.
6 Fold bassinet.
7 Place bassinet in pocket of
travel bag.
IMPORTANT: If continuing to use Playard, be sure to
properly secure floorboard in Playard.
1 To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set
aside.
2 Lift Floor Handle, rotate
counterclockwise to unlock
floor and pull up,
approximately 45.7 cm
(18 inches).
3 To fold top rails:
• Pull up on top rail slightly.
• Squeeze Release Button
on bottom of top rail and
push rail down. (Release
buttons are identified by
printed arrows.)
Repeat for other sides.
NOTE:
• If rails are difficult to
unlock, raise center of
floor higher and
squeeze Release
Button again.
• If only one side of rail
folds, squeeze Release
Button again to fully
fold.
FOLDING and STORING continued
8
Playard
Release
Button
Floor
Handle
Handle
Attachment
Straps
Floor Loop
Handle
Opening
Floor Loop