Filter
Top Products
5 Insert one side of floorboard
under Pocket on side of
bassinet.
6 Pull Pocket down over
floorboard to hold
floorboard in place.
Repeat steps 5 and 6 for
other side of floorboard.
7 Push down on center of
floorboard to flatten.
Bassinet assembly is now complete.
• Bassinet can be used with or without changer.
• Bassinet can be used with or without Playard.
To use bassinet with Playard:
1 Place bassinet in Playard so that
hooks go over long rails with
“T-Slots” facing center of
Playard.
NOTE: “T-Slots” MUST face
center of Playard when using
with changer.
2 Secure bassinet to Playard:
• Pass Attachment Strap
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
Repeat for other strap.
Bassinet is now ready for use with Playard.
1
Lay changer on flat surface.
2 Grasp middle of each long side
and gently pull apart until short
sides “click” and lock in place.
NOTE: Make sure changer sides
are fully extended and locked.
ASSEMBLY and USE continued
5
1
Set bassinet on flat and stable surface that will keep
floorboard level so child will not roll into corner or side of
bassinet resulting in breathing difficulties.
2 Keep at least 30.5 cm (12 inches) away from surface edges
and stay within reach of child. Child’s wiggling and rocking
may cause bassinet to move and possibly fall off surfaces.
WARNING
Prevent falls and suffocation:
• Use only on a surface that is flat, level and
stable.
• Keep bassinet away from surface edges.
Attachment
Strap
Pocket
Pockets
Changer
WARNING
Avoid serious injury or death:
• Always use restraint belt to prevent falls.
• Use with infant who weighs less than 8.2 kg
(18 lbs.) and is less than 63.5 cm (25 inches)
tall.
• Discontinue use of changer if infant can
push up on hands and knees or sit
unassisted.
• DO NOT carry changer with infant in it.
T
o use bassinet without Playard:
Changer can only
be used when bassinet is
installed in Playard.
“T-Slots”
Triangular
Tab
T-Fitting