Filter
Top Products
ENGLISH
❃ Lock Footrest:
1 Push footrest down so that frame
tube is centered between three
(3) tabs on bottom of footrest
and snaps into place.
❃ Rear Wheel Assembly:
1 Remove axle protectors from ends of axle and discard.
2 Rotate brake lever to the unlocked
position and slide wheel onto each
end of axle rod with brake ribs
facing in.
3 Attach wheel to axle:
• Snap wheel retainer onto grooved end of axle. Make sure
large end of wheel retainer is towards wheel.
• Snap wheel retainer cap over wheel retainer.
CAUTION:
- Failure to install retainer cap may cause wheels to
come off of stroller.
- After wheel assembly is complete, pull on wheels
to check that they are locked into place.
• Line up hub cap tabs with slots in wheel and snap hub
cap into place.
WARNING
Prevent possible choking hazard: discard axle
protectors and polybag which contained rear wheel
parts.
3
CAR SEAT/STROLLER ASSEMBLY
❃ Opening Stroller:
1 Stand stroller upright and pull tab
up to release latch.
2 Spread handle and rear legs until
both fold locks “click” into position.
❃ Front Wheel Assembly:
1 Hold swivel wheel assembly upright
(tab pointing down).
2 Tilt stroller slightly back and push
wheel assembly up onto leg until it
locks in place.
Repeat steps 1 & 2 for opposite leg.
.
CAUTION: After wheel
assembly is complete, pull on
wheels to check that they are
locked into place.
Tab
Stroller Left
Side
Stroller Right
Side
Retainer
Cap
Wheel
Hub
Cap
Wheel
Retainer
Brake Lever
Tabs
Brake Ribs