Filter
Top Products
Configuring Digital Keyboard Settings
EN-57
English
■ MIXER Screen
This screen mixer lets you adjust the source tone, volume level, and other setting items of the Digital Keyboard
sound source parts (Parts 01 through 16), while viewing the balance between the parts on the display. For details,
see “Using the Sliders” (page EN-24).
• Besides part 01 through 16, the MIXER screen can be used to change External (external parts) and Mix (all parts)
settings. Note, however, that External and Mix can be used to change only the parameters below.
External: Volume, Reverb Send, Chorus Send, Delay Send, Line Select
Mix: Volume
• When “Solo” is turned on, pressing a keyboard key sounds that part only. All other types of performance
operations (layer, split, Auto Accompaniment, etc.) are disabled.
Item Meaning Setting
Part A part that is turned on is sounded. Turn off parts you do not want to sound. Off, On
Tone Changes the tone. 1100 (MZ-X500),
900 (MZ-X300)
Solo Turn on to sound the applicable part only. Off, On
Volume Adjusts the volume. The volume level of each part is shown by an on-screen
level meter.
0 to 127
Pan Specifies the stereo pan position of the sound output by the Digital
Keyboard. 0 indicates the center, while a smaller values shifts to the left and
a larger value shifts to the right.
–64 to 0 to +63
Coarse Tune Specifies, in semitone steps, the pitch of the notes of each part. –24 to 0 to +24
Fine Tune Specifies, in cent steps, the pitch of the notes of each part. –99 to 0 to +99
Bend Range Adjusts, in semitone steps, the bend range of each part. 0 to 24
Reverb Send Specifies how much reverb is applied to each part.
No reverb is applied at all when this setting is 0, while maximum reverb is
applied when it is 127.
0 to 127
Chorus Send Specifies how much chorus is applied to each part.
No chorus is applied at all when this setting is 0, while maximum chorus is
applied when it is 127.
0 to 127
Delay Send Specifies how much delay is applied to each part.
No delay is applied at all when this setting is 0, while maximum delay is
applied when it is 127.
0 to 127
Line Select Specifies which DSP is applied to the selected part. Off, DSP1, DSP2
Port Specifies the port. For information about MIDI channels assigned to each
port, see “Part and MIDI Channel Assignments and Diagram” in the
separate “Tutorial” manual.
Port A, Port B,
Port C
Level/Param switch Toggles the level meter display between volume levels and parameter
settings.
Param, Level
Level meter Shows the volume level or setting of each part. –
Level meter
MZX300_X500-ES-1A.indd 59 2015/10/07 15:46:50