Britax LATCHANCHOR Baby Carrier User Manual


 
Versa-Tether
TM
7
Verify that there is tension in the tether strap and that child
restraint is properly secured.
IMPORTANT:
The proper child restraint angle is the angle where your
child rests comfortably back, but never more than 45 degrees from
vertical.
Releasing the Versa-Tether
To release the Versa-Tether, push the adjuster button down and
inwards on the tether strap, and pull to loosen. Unhook the teth-
er from tether anchor point to release child
restraint
. This method
occasionally may be difficult. An alternative method is to release
the seat belt first.
Using the Tether Connector Strap (rear facing only)
Sometimes it is not possible to find a location to properly anchor the
tether or the structural part of the seat is too large for the hook. Use
the tether connector strap to assist in connecting to an anchor point.
1 Locate a seat frame bar, vehicle seat leg, or a fixed vehicle seat belt
anchor that is bolted to the floor which the strap can be wrapped
around.
2 Loop the strap around the metal
anchor, then take the metal d-ring
and lace it through the hole on the
other side of the strap.
3 Pull the metal d-ring all the way
through until strap is tight around
the tether anchor.
4 Attach the tether hook to the
strap or d-ring.
28
FAGalaxy_page proof 2/9/02 11:17 AM Page 28