Filter
Top Products
Installation: Rear Facing
16
7 Press child restraint into vehicle
seat, while removing slack from
the seat belt (fig. D).
8
Position seat belt through the
open lock-off.
9
Close lock-off arm. Lock-off is
properly closed when a positive
click is heard
(
fig. E)
.
NOTE: It is only necessary to use
one lock-off. Always use the lock-
off that is closest to the seat belt
buckle.
Never bend the plastic
lock-off arm up or down to pre-
vent breakage. Do not route LATCH
Harness through the rear facing
lock-offs when installing with vehicle
seat belt.
10 Attach Versa-Tether
™
as in-
structed on pages 27
–
28. Rear facinginstallation is improved by the
use of the Versa-Tether
™
, but is not required.
11 Verify that the seat belt is tight and the child restraint is secure.
Removal
To remove the child restraint, unfasten the seat belt and reverse the
above directions.
E
D
FAGalaxy_page proof 2/9/02 11:17 AM Page 16