Filter
Top Products
1514
Installation
Installation
Lap Belt Installation
Figure A illustrates a typical lap belt
configuration.
1 Insert recline bar into holes on
rear of restraint
(See page 18)
.
2 Place the child restraint in a
forward facing position on the
vehicle seat.
3
Pull the vehicle belt out, then pass
the vehicle belt through the first belt
slot, from the front of the restraint to
the rear
(Fig. B)
.
4
Route the vehicle belt around
the back of the restraint then
through the second belt slot,
from the rear of the restraint to
the front
(Fig. C)
.
B
A
C
5
Verify that the vehicle belt is
not twisted, then buckle. (
Fig. D)
.
6 Push restraint into the vehicle
seat with your full weight while
removing all slack from the vehicle
belt
(
Fig. E).
7 Verify that the vehicle belt is
tight and the child restraint is
secure.
Installation can be improved by the
use of the Versa-Tether
™
(see
pages 16–17).
IMPORTANT:
Always use the
Versa-Tether for children
weighing more than 50 pounds
(22.6 kg).
Removal
To remove the child restraint,
unfasten the vehicle belt and
reverse the above directions.
D
E
P2219_R02f.qxd 11/7/2002 10:23 AM Page 16