Filter
Top Products
The buckle has two positions and
should be adjusted to fit your child
(Fig. D). Select the slot closest to, but
not under, the child.
WARNING:
Do not use position two (2)
until child exceeds 50 pounds (22.6 kg)!
Remove the buckle, then rethread in
appropriate position. See page 26 for
buckle removal and rethreading
instructions.
2322
Harness Height Adjustment
Harness Height Adjustment
4 Thread the harness straps through the
appropriate harness slots (Fig. C).
5 Reattach harness straps to the yoke.
6 Pull harness adjuster strap to tighten the
harness.
7 Verify that all straps are threaded at the
same height and are not twisted.
Checking Harness Height:
1 Place child in restraint, then secure
harness (see pages
20–21
).
2 Observe where the shoulder harness is
positioned on your child.
•
Harness Straps should be located in
the nearest slot at or above the child’s
shoulder.
3 If harness height is okay, continue using
child restraint without adjustment. If
harness height requires adjustment, refer
to Adjusting Harness Height below.
NOTE:
Once the top slots become
necessary, your child may continue to use
the restraint until the top of the ears become
level with the top of the restraint shell, or
child weight exceeds 80 pounds (36 kg).
Harness Height Adjustment
1 Loosen the harness, by lifting the harness
release lever while pulling the shoulder
straps forward as far as possible (Fig. A).
2 From the rear of the child restraint,
unhook the shoulder harness from the
yoke (Fig. B).
3 Pull straps through the shell and cover,
to the front of the restraint.
B
C
A
Adjusting Buckle Position
D
P2219_R02f.qxd 11/7/2002 10:23 AM Page 24