Filter
Top Products
1918
Using Restraint Features
Using the Buckle
Fastening the Buckle
1 Hold the buckle with one hand.
2 Use your other hand to insert one
tongue at a time into the buckle. Proper
connection is confirmed with a positive
click, after inserting the second buckle
tongue
(
Fig. B
)
.
Releasing the Buckle
1 Brace the rear of the buckle with hand.
2 Use thumb to press release button until tongues are ejected from
buckle
(
Fig. B
)
.
NOTE: Periodically clean the buckle to ensure proper operation.
See
page 27.
Recline Bar
THE RECLINE BAR MUST BE INSTALLED
BEFORE USING THIS RESTRAINT.
Insert recline bar into the holes in lower
rear of restraint
prior to installation in
vehicle (Fig. A)
.
IMPORTANT: The bottom of the restraint
must be flat on the vehicle seat when
installed.
Using the Chest Clip
Open the chest clip by squeezing the middle
tab, then pull the two pieces apart
(
Fig. C
)
.
IMPORTANT: The correct height for the
chest clip is at the middle of the chest, level
with the armpit.
B
Using Restraint Features
C
A
P2219_R02f.qxd 11/7/2002 10:23 AM Page 20