Filter
Top Products
Open both lock-offs. Pull off suffi cient lap
and diagonal belt (approx. 600-900mm).
Feed the belt through the lock-off belt
guide on the opposite side to the buckle
and in to the belt tunnel (dia 2b). There
are two access slots in the seat cover to
aid feeding of the belt through the belt
tunnel and underneath the seat cover (dia
2b inset).
Feed the seat belt through the belt tunnel
and lock-off on the opposite side and
attach the tongue into the buckle (dia 2c).
IMPORTANT - The child seat MUST only be used with a lap or a lap and
diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent
standards).
With the footprop adjusted to the shortest length, place the child seat rearward
facing on the car seat with the swinging base resting against the back of the
vehicle seat. After installation the gap between the seat in front and the child
seat should ideally be a minimum of 10mm (dia 2a).
The child seat can touch the seat in front but must not rest against it. If it does
then adjust the car seat in the front without making the driver or passenger sit
in an uncomfortable position. If not try another seating position in the car.
2. Installing your child seat (rearward facing) in rear side seat
2a
2c
Pull all the seat belt slack through the child seat ensuring the seat belt is not
twisted. When the belt is as tight as possible, close the lock-off on the seat belt
buckle side, ensuring that both the lap and diagonal sections of the belt are
secured by it (dia 2d inset).
Close the lock-off on the opposite side, ensuring that only the lap section of the
belt is secured by it (dia 2d).
Ensure that both lock-offs have been clicked into place.
If the buckle now lies in the position marked as wrong with a
and the seat
belt cannot be correctly tightened (dia 2e), try another seating position in the
car.
2e
2b
2d
Britax_2h.indb 8 30/10/2007 16:23:52