Filter
Top Products
42
43
Harness Buckle Removal
Recline the child seat.1
Locate the metal buckle strap retainer on 2
bottom of the child seat.
Pull retainer away from child seat to loosen.3
Turn the retainer so the short side will go 4
through the slot in child seat shell (Fig. A).
Push the retainer through slots in the shell 5
and cover, to the top of the child seat.
Re-threading the Harness Buckle
IMPORTANT: See Adjusting Harness Buckle Position on page 38 for
important instructions on proper buckle placement based on your child’s
size.
Locate slot in cover and shell for harness buckle.1
Turn the buckle retainer so the short side will go through the slot in 2
the cover and child seat shell (Fig. A).
Push the retainer through slots in the shell and cover, to the bottom 3
of the child seat.
Pull harness buckle away from child seat until tight and verify the 4
strap is not twisted and the release button is facing outward.
A
Care and Maintenance Care and Maintenance
Cleaning the Cover
HAND WASH using cold water and mild soap.•
LINE or LIE-FLAT DRY to prevent cover from shrinking.•
DO NOT • bleach, machine wash, machine dry, or iron the cover.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap.•
TOWEL DRY•
DO NOT • use solvents, abrasive cleaners, or disassemble the harness.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap.•
TOWEL DRY•
DO NOT • bleach, machine wash, machine dry, iron or disassemble the
harness.
Cleaning the Harness Buckle
If a child eats and drinks while in the child seat,
the harness buckle may need to be periodically
checked and cleaned of any accumulated food,
drink or other debris.
REMOVE BUCKLE as described on page 43.•
THOROUGHLY RINSE using warm water (Fig. •
A).
TEST THE HARNESS BUCKLE by fastening •
and unfastening until an audible click is heard
after inserting each buckle tongue (Fig. B).
If either click is not heard, repeat cleaning
procedure.
TOWEL DRY•
DO NOT• lubricate, use solvents, abrasive
cleaners, soap or other household detergents.
A
CLICK
x 2
B