Filter
Top Products
18
19
Installation: Rear-facing Installation: Rear-facing
Lap-Shoulder Belt Installation
Figure A illustrates a typical rear-facing, lap-•
shoulder belt installation.
When not in use, always store the LATCH •
connectors in the storage slots.
See page 34.
See vehicle owner’s manual to determine what •
type of seat belt system your vehicle has, and
how to lock it (also see pg 10-13).
IMPORTANT: This child seat is shipped with the
buckle in position 1 (Fig. B). Use buckle position
1 or 2 that is closest to but not underneath your
child. Do not use buckle position 3 in rear-facing
mode. See page 38 for Adjusting Harness Buckle
Position.
A
Recline the child seat then place it rear-facing 1
on the vehicle seat.
This child seat must be in
the recline position when installed rear-facing.
See Recline Adjustment on page 34.
Pull the vehicle belt out then pass it through 2
the first rear-facing belt slot (Fig. C).
Route the vehicle belt across the child 3
seat and then through the second rear-
facing belt slot.
IMPORTANT:
The vehicle belt must rest • IN FRONT OF the
child seat buckle when using buckle slots 1
or 2 (Fig. B).
Vehicle belt can be routed over or under the •
cover.
Verify that the vehicle belt is not twisted and 4
then buckle (Fig. D).
Push the child seat firmly into the vehicle seat 5
while removing slack first from the lap portion
of the vehicle belt, then the shoulder portion
(Fig. E).
Ensure the vehicle seat belt system is locked.•
If your vehicle is not equipped with a lockable •
seat belt system, use of a locking clip may
be required. See page 35 for locking clip
instructions
Verify that the vehicle belt is tight, locked and 6
that the child seat is secure.
The child seat is secure when it cannot be •
moved more than one inch (2.5 cm) front-to-
back or side-to-side at the belt path.
When properly installed in the rear-facing •
position, the back angle of the child seat should
be 30º – 45º from vertical (not to exceed 45º)
when the car is parked on a level surface (Fig.
F).
If necessary, the proper recline angle can be •
achieved by placing a rolled towel or pool
noodle in the crease of the vehicle seat to level
the child seat’s base.
Rear-facing installation can be improved by using the Versa-Tether see •
pages 29 - 32.
D
B
E
C
F
WARNING! Do not raise the child
seat off the front edge of the vehicle seat.
This could cause your child seat not to
perform as intended.