Filter
Top Products
Extend canopy to expose
lower fabric screw.
Remove screw with
Phillips screwdriver,
exposing fabric
grommet and
rivet nut.
Repeat on other side.
INSERT SHARP SCREW
ATTACH RESTRAINT BELT M/F AND ARMS
LOCATE FABRIC SCREWS REMOVE FABRIC SCREW
Insert sharp screw through end of
arm, restraint belt grommet, fabric
grommet and into rivet nut.
Note:
If screw does not turn easily,
unscrew and start again.
Position arm between canopy and frame.
POSITION ARM
TIGHTEN SHARP SCREW
Tighten rmly with
Phillips screwdriver.
Red pull ring
should face out.
ATTACH RESTRAINT BELT M
POSITION RESTRAINT BELT M
Slide restraint belt M grommet between
end of arm and fabric grommet.
Align arm hole over
fabric grommet
and rivet nut.
OMA09D P3
90°
Hold strap at a 90
degree angle.