Filter
Top Products
English 6
Registering with a Receiver (Pairing)
This scale needs to be registered with a receiver in order to use Bluetooth communication with the
receiver. The process of registering this scale with a receiver is known as pairing.
When pairing is completed, measurement data from this scale is automatically sent to the paired device
each time a measurement is made when the receiver is in the state in which it can receive transmissions.
Consult the receiver instruction manual and set it to enable pairing. If the receiver has a "pairing wizard",
use the wizard to complete pairing.
Place the receiver and this scale as close as possible to carry out pairing.
1.
Install four AA size alkaline batteries into
this scale.
For details, see "Installing (or Replacing) the Batteries (P.5)".
2.
Confirm that "Pr" is displayed.
" " flashes.
This scale is discoverable by the receiver.
Pairing can be skipped using the following method.
i Press the setting switch when "Pr" is displayed.
Beep
3.
Start pairing on the receiver.
Follow the pairing instructions for the receiver to search for,
select and pair with this scale.
If a PIN code is requested by the receiver, enter "39121440".
4.
Confirm that "End" is displayed.
Pairing completed.
If "E-10" or "E-11" is displayed, perform the pairing procedure
again from step 1.
Beep beep
This scale can be paired with two receivers.
If this scale is paired with a third receiver, the information of the receiver that was communicated with
most recently remains.
Once the scale paired with the receiver, it is no need to perform pairing after replacing batteries.
Cautions for Pairing
Turn the power of other Bluetooth devices off when performing pairing.
Multiple devices cannot be paired at the same time.
If measurement data cannot be received, try pairing again.
After pairing is complete, all communications are done automatically.
To unpair a receiver, see "Unpairing (P.10)".
In the unlikely event that this scale causes radio wave interference to another wireless station,
either change the location where the scale is used or stop using the scale immediately.