Filter
Top Products
English 10
Other Functions
Unpairing
1.
Confirm that the scale is
turned off, and press and
hold the setting switch.
When the setting switch is
continuously pressed, "unit" and
"uPr" are alternately displayed.
Beep
2.
Release the setting
switch when "uPr" is
displayed.
Beep
3.
Confirm that "End" is
displayed.
The receiver is unpaired.
If "E-10" or "E-11" is displayed,
perform the unpairing procedure
again from step 1.
The scale turns off automatically.
Beep beep
Transmitting Temporarily Stored Data
If measurement data cannot be sent to a receiver, this scale can temporarily store data of a maximum of
200 measurements in the built-in memory. When the scale is able to transmit to a receiver, all of the data
is transmitted. If the amount of data temporarily stored exceeds 200 measurements, the oldest data is
deleted and replaced with new data.
Stored data cannot be viewed on this scale.
The maximum amount of data that can be temporarily stored may differ depending on the receiver.