Filter
Top Products
13
Operation (Continued)
Emergency Stop Button
The E-Stop button can be pushed at any time to
stop machine operation and bleed air from the
pneumatic system.
Reset Button
When case former is stopped with E-Stop, the Reset
Button must be pushed to restore air supply to the
machine.
Box Centering Guide
The four knobs for locking the centering guides in
position are located at the front and rear of the
machine. Center the box in the machine with the
centering guides and tighten the knobs to lock
guides in place.
Box Ejector
The ejector and air cylinder are located on the top
center rail of the case former as shown in Figure 3-2.
The ejector is adjustable along the rail in 25 mm
[1 inch] increments to accommodate box lengths
from 205 mm [8 inch] minimum to 600 [23-1/2 inch]
maximum.
Manual Operating Procedure
(Top and Bottom Taping)
Refer to Figures 3-2 and 3-3
1. Turn case former air valve "On" (SUP).
2. Turn Manual/Auto valve to "Man".
3. Hold the empty box over the center rail. Fold
the front bottom flap on the rail and rear bottom
flap on the carton ejector.
4. Move box forward (toward case sealer) until
both side bottom flaps contact the bottom flap
actuator plates. The two bed plates will then
rotate up and fold the side box flaps up.
Figure 3-3 – Box Placement
5. Fill the box with product.
6. Close box top flaps, front and rear and then side
flaps.
7. While holding top flaps down, press "Eject"
button to move box into case sealer. Hold top
flaps down until box moves into case sealer.
The ejector will return to the rest position and
the bed plates will return to full open position
ready for the next box.