Assembly 37
MAN0810 (9/24/2009)
Install CV Drive
1. Align hole in drive yoke with groove on gearbox
input shaft and slide rear half of drive (5) onto
shaft.
2. Secure with bolt and nut supplied with drive.
Figure 26. CV Drive Installation
Install Wing
Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
The wing must be installed in the following sequence
and will require at least two people. A floor jack or a
suitable lifting device will be helpful to align decks
when installing the hinge pin.
1. Attach winglet (7) to wing using three carriage bolts
(69) and flange lock nuts (70).
2. Remove hinge pin (11) from center section.
3. Place wing assembly adjacent to the center section
and align hinge sections.
4. Insert hinge pin through the hinge sections and
secure with spring pin (81) and washer (52) on
both ends.
5. Attach side skid (6) to the wing using four carriage
bolts (66) and flange lock nuts (68).
6. Repeat procedure of opposite wing.
Figure 27. Right Wing Installation
Install Wing Cylinder & Lock-up Bar
Figure 28. Wing Cylinder & Lock-Up Bar Installation
1. Place two cylinder links (11 & 12) on either side of
cylinder lug on center section as shown, align
holes and insert clevis pin (33).
NOTE: Items 11 & 12 must be installed with square
corners on top and facing cylinder as shown.
6. Skid Shoe
7. Winglet
11. Hinge Pin
52. 1” Flat Washer
66. 1/2 NC x 1 Carriage Bolt
68. 1/2 NC Lock Nut
69. 3/8 NC x 1 Carriage
Bolt
70. 3/8 NC Lock Nut
81. 1/4 x 1-1/2 Spring
4. Hydraulic cylinder
11. Cylinder link
12. Cylinder Link
13. Wing lock-up bar
32. 1" x 2.72" Headless
pin
33. 1" x 4.08" Headless
pin
35. Lock-up pin 1" x 5"
37. Spacer, 3/4
38. Spacer, 1"
27. Washer, 1 x 1-7/8
40. 1/2" x 1/4" Pipe
reducer bushing
41. 1/4 " x 1/4" Elbow w/
1/16" restricter
43. 1/4" x 1/4" x 200"
Hose
52. 1" Flat washer
53. 1" x 1-7/8" x 1/4"
Washer
80. 1/4" x 1-1/2" Cotter
pin
83. 3/16" Safety pin
