Assembly 35
MAN0810 (9/24/2009)
Install Height Adjustment Cylinder
Refer to Figure 23.
1. Attach base end of cylinder (21) to the spring arm
(19) using clevis pin (32) and two cotter pins (80).
2. Extend cylinder rod and place transport lock
bracket (22) over cylinder rod clevis.
3. Position cylinder rod and transport lock bracket
between lugs on the wheel yoke tube and align
holes.
4. Secure cylinder rod and transport lock bracket to
the wheel yoke tube using clevis pin (34) and two
cotter pins (80).
5. Install bushing (40), elbow, (41) and hose (42) to
the base end of cylinder (21). See Install Hose Kit,
page 39 for complete instructions.
NOTE: An optional ratchet (24) is available, and
replaces the hydraulic cylinder. Install ratchet jack
using the same procedure and hardware used for
the installation of the hydraulic cylinder.
Install SMV Emblem
Refer to Figure 23.
1. Attach SMV mounting bracket (25) to left side of
center section as shown using two carriage bolts
(66) and flange lock nuts (68).
2. Attach SMV socket (26) to mounting bracket (25)
using two carriage bolts (73) and lock nuts (77).
3. Attach SMV emblem (28) to SMV bracket (27)
using two round head cap screws (78) and hex
nuts (79).
Insert SMV bracket (27) and emblem (28) into
socket (26).
Figure 23. Spring Arm and Cylinder Installation
19. Spring arm
20. Spring
21. Hydraulic cylinder 3 x 8
22. Transport lock-up
23. 1-1/4 Cylinder stroke control kit
24. Rachet adjustabel link bundle
25. SMV Mounting link
26. SMV Socket
27. SMV Bracket
28. SMV Emblem
32. 1 x 2.72 Headless pin
33. 1 x 4.08 Headless pin
34. 1 x 4.58 Headless pin
38. Spacer, 1"
40. 1/2 x 1/4 Pipe
reducer bushing
41. 1/4 x 1/4 Elbow w/
1/16 restricter
42. 1/4 x 1/4 x 156 Hose
65. 1/2 NC x 4-1/2 HHCS
GR5
66. 1/2 NC x 1 Carriage bolt, GR5
68. 1/2 NC Flanged lock nut
73. 5/16 NC x 3/4 Carriage bolt
77. 5/16 NC Flanged lock nut
78. 1/4 NC x 1/2 Round head screw
79. 1/4 NC Hex nut
80. 1/4 x 1-1/2 Cotter pin
